While your Expel Workbench administrator can set up your account, only you can activate it. When your account is ready, Workbench sends you an activation invite.

Tip

Invitations expire, so don't delay!

Install Google Authenticator on your smartphone or other portable device with a built-in camera.

Activate your Workbench account

To activate a Workbench account, take these steps:

  1. Check your email for an activation invite from Workbench. If you didn't receive the invite, or it expired, contact your Workbench administrator.

  2. Open your invite and click Set Up My Account.

    mceclip8.png
  3. Create a password by following the on-screen instructions, then click Next.

    Note

    Your email address is your Workbench username.

    WB_Create_password.png
  4. Verify your account by following the on-screen instructions, then click Next.

    WB_Add_user_enable_google_authenticate.png

    If you see this message, activation failed. Contact your Workbench administrator and start over at Step 1.

    WB_Setup_account_error.png

    If you see this message, activation was successful. The Workbench login screen appears momentarily.

    WB_Add_user_Success.png
  5. Log into Workbench using your email address and the password you just created.

    mceclip4.png

    Workbench appears.

    Note

    The screen you see on login depends upon your user profile settings. Alert analysis dashboard (shown below) is the default screen.

    mceclip5.png